- Chelsea Green - http://www.chelseagreen.com/content -

Maple Syrup 101: When Do I Tap My Tree?

Posted By admin On January 13, 2014 @ 9:47 am In Food & Health,Garden & Agriculture | Comments Disabled

With sugaring season almost upon us, many folks are already setting their eyes on a nearby stand of maple trees and getting ready to set taps, run lines, and collect sap.

If you only have a couple of trees nearby — say in your backyard — author Mike Farrell (The Sugarmaker’s Companion [1]) has some simple advice for you to get started tapping a few trees and collecting the sap by bucket. The following is adapted and condensed from Chapter 5 of his book [1].

Happy sap collecting!

Backyard Sap Collection When to Tap

One of the most difficult decisions you have to make from year to year in your sugaring operation is deciding when to tap. I always recommend tapping just a few trees in January and February to determine what is going on with sap flow conditions. In relatively cold areas, even when the temperatures get above freezing in January and February, the amount of sap flow can be negligible. The trees are basically frozen, and it takes an extended period of warm temperatures to induce substantial sap flow. In warmer regions where the winter isn’t as severe, optimum temperature fluctuations usually happen all winter and the trees may be producing a decent amount of sap in January and February. If you see this happening in your test trees, you’ll want to tap the rest of your sugarbush to catch the early sap runs.

How to Tap

Finding the Right Spot

The first step in tapping is to find a good spot to drill the hole. It doesn’t matter how nice a hole you drill, what type of spout you use, or what level of vacuum you are pulling if you have drilled into a bad section of the tree. To get a decent amount of high-quality sap, you need to drill into clear, white sapwood. It is important to avoid previous tapholes and the associated stain columns as well as other defects and rotten areas on the trunk. Large seams and wounds are easy to identify and avoid, but it takes a trained eye to locate old tapholes.

Drilling the Hole

Sugaring Tap

Some people advocate drilling the hole directly into the tree whereas others recommend drilling at a slight upward angle. I usually try to achieve a perfectly straight hole but always err on the side of making it at a slight upward angle whenever necessary. No matter how you drill the hole, be sure to use a relatively new, clean, sharp drill bit that is intended for drilling into maple trees.

When you are pulling the drill out of the tree, always examine the shavings to make sure that they are pure white. If you get brown or dark-colored shavings, you have drilled into a bad part of the tree. Your sap yield will be negligible, and any sap that does flow may have a yellow tinge to it and impart off-flavors to your syrup.

Setting the Spout

The final step is placing the spout in the tree. It takes some practice to figure out how hard to tap on the spout to get it nice and snug without overdoing things. Not tapping in hard enough can cause the spout to be too loose, creating a vacuum leak. On the other hand, tapping too hard can potentially cause the wood to split, which in turn leads to vacuum leaks, lost sap, and increased wounding at the taphole. Most sugarmakers use regular hammers to set the spouts, but you don’t necessarily hammer the spouts in. Just a few gentle taps will usually do the trick until you hear a thumping sound. As soon as you can hear the difference, stop tapping on the spout.

Row of Sugaring buckets


Article printed from Chelsea Green: http://www.chelseagreen.com/content

URL to article: http://www.chelseagreen.com/content/maple-syrup-101-tap-tree-2/

URLs in this post:

[1] The Sugarmaker’s Companion: http://www.chelseagreen.com/bookstore/item/the_sugarmakers_companion:paperback

Follow us
Get every new post delivered to your inbox
Join millions of other followers
Powered By WPFruits.com